[Nameplate] Fair ~ 48°F  
High: 52°F ~ Low: 42°F
Friday, Nov. 28, 2014

Rapid, essential work comes after that deer kill

Monday, October 24, 2011

(Photo)
Hooray, yippee and wow! You have killed a deer. Now what?

Whether the first-timer is a boy or girl 10 years old, or a man or woman on the top side of 50, it's a special moment, a unique experience in the outdoors.

Your first deer. After the adrenaline rush passes, there is the dead animal lying on the ground.

Chances are very good that there will be help close by or at least available -- help defined as someone with previous deer hunting and handling experience.

It is best to be prepared, though, even if the novice is hunting with a platoon of Daniel Boone clones.

Experienced deer hunters with the Arkansas Game and Fish Commission offer a first suggestion: After the deer has been downed, after there is no doubt about it being dead -- wait.

Stay some more minutes in the tree stand or in the spot of firing the shot. Just wait a few minutes. Sometimes even a fatally hit deer will jump up and run or try to.

Next, when you are standing by the dead deer, and it is truly dead, unload your rifle or shotgun and put it aside.

Before moving the animal, make sure to tag the deer and provide all of the required information.

Then, decide if the carcass should be taken to camp or to where help is available, whole or field dressed.

High up in this decision is how quickly can it be cooled so the meat doesn't spoil. This is a key factor in winding up with venison to be proud of on the dinner table.

If moving a whole carcass is in order, forget any notions of throwing it over your shoulder and walking out of the woods.

This doesn't happen unless you have killed a 50- or 60-pound deer. It doesn't happen even if you are a weight-room legend and starting left tackle on the football team.

To move a dead deer, you drag it. If it is a doe, turn it on its back, step between the two hind legs, grab one with each hand and walk.

If it is a buck, use the antlers for a handle and drag if from the front.

Your belt or a short piece of rope you've brought along becomes most handy here.

Field dressing is a polite term for gutting. It means to remove the entrails of the carcass.

Should the decision be to field dress, go with it. You have to have a knife. It doesn't need to be a Bowie knife nor a pen knife; a sharp knife of most any sort will work.

Roll the carcass on its back and begin at the neck. Make one firm but shallow cut through the hide and hair from the neck to the back end.

Start the cut then pause and work two fingers into the opening.

Carefully keep the knife blade between your fingers and use the fingers to keep the hide away from organs inside.

What you must avoid is cutting into the intestines. Make this mistake, and the meat may be ruined for eating.

Especially avoid slicing into the bladder near the finish of your cut. When the cut is finished, pull the opening as far apart as you can. Here, you may want to take off jacket and shirt, down to a T-shirt.

Then reach in at the neck and start pulling everything out, all the way down to the back end. Messy? Yes, it is. But it has to be done.

When the organs are out, check inside the cavity for anything else than needs to come out.

You'll have to cut the windpipe loose with the knife. If grass is handy, grab a couple of good handfuls and wipe the inside -- or use some paper towels or toilet paper that you had stuffed in a pocket.

Now the weight of the carcass has been reduced by at least a fourth for quicker cooling and easier dragging.

Hopefully, it won't be far to a vehicle, even an ATV.



Respond to this story

Posting a comment requires free registration. If you already have an account on this site, enter your username and password below. Otherwise, click here to register.

Username:

Password:  (Forgot your password?)

Your comments:
Please be respectful of others and try to stay on topic.